![]() In this case, the COM1 in the VM is created in device manager.įor Arduino IDE, it detect COM1 and I can use monitor but Uplaod target doesn’t work.įor PIO I don’t need to set “upload_port = COM3” as it detect the COM1 in device manager. In this case, I create a new pipe for the VM COM1 which is available on the host and I redirect this pipe to the HOST COM3 I’m able to program the target with Arduino IDE but not with PIO (I don’t know which parameter to program for COM) ![]() I’m able to connect the COM3 with : PUTTY, Arduino IDE Monitor, PIO Monitor (if I set upload_port = COM3) ![]() With this mode, the COM PORT isn’t show in device manager (normal with HyperV gen2) but I can see it in REGEDIT (HKEY_LOCAL_MACHINE\HARDWARE\DEVICEMAP\SERIALCOMM\device\VCP0=COM3) I can connect the HOST COM3 (which is a FTDI USBUART Breakout Board) on the VM in two different way : I made several test with PlatformIO installed on a HyperV Virtual Machine (VM).Īs already explained, the issue is with the programmer Upload of the Arduino target (TinyUSB or ArduinoISP).
0 Comments
Leave a Reply. |